Solved my problem an easy way to set up à angle on the mill leaving the table settings alone, as with any new tool you just have to learn it's benefits and limitations. Top and bottom are reasonably parallel in the lengthwise direction, the surface is flat and the sliding surfaces glide smoothly. Remember to tighten the brake/holding screws before aligning with the dial gauge, there is a little play. The degree division at the end is only a guide line and only for an approximate setting, there is a lot of backlash in the worm gear and it has a slightly rough and uneven gait, but remember to only aproach one way and it will work. All in all, a nice piece of tool for the price.

Nachdem schon einige sich über den geringeren Neigungsbereich beschwert hatten, habe ich das Teil doch gekauft. Bei der Erstreinigung fiel auf, dass die Lagerböcke von der falschen Seite bearbeitet sind, denn an der Rückseite befinden sich die nötigen Abschrägungen. Jetzt einen Bock auch auf der anderen Seite mit 45 Grad abgeschrägt und der Kippbereich ist auf 45 Grad erweitert.

einwandfreie Funktion. Präzise wie Hund. Ich freu mich darüber

i.O.

I use it on my milling machine for model engineering.

I only wish about 15 years ago I could have afforded something like this for my drill/mill.

Solid table, easy to adjust. Good addition for angled holding on mill

Only downside was the need to do some fettling to get the rotational angle setting to work properly

This was shipped in a really nice, wooden box that supported my purchase so that it arrived in great shape. It was well oiled and works nicely. Very satisfied with this purchase!

I removed the rotary screw mechanism and coupled it with a linear actuator for an automated tilt table. The table has no side slop so it can be easily actuated.